10
CAUTION:
NEVER WIRE, CLAMP OR
OTHERWISE DISABLE THE LIFT CONTROL
VALVE TO FUCTION BY ANY MEANS
OTHER THAN BY USING THE OPERATOR'S
HAND. USE THE HANDLE PROVIDED WITH
THIS PRODUCT OR AN AUTHORIZED
REPLACEMENT HANDLE TO ENSURE
PROPER RELEASE VALVE OPERATION. DO
NOT USE EXTENSIONS ON THE AIR HOSE
OR ON THE OPERATING HANDLE.
LOWERING THE JACK
1. Raise load high enough to allow clearance for the
jack stands to be removed, then carefully remove
jack stands.
2. Remove support stands.
3. Grasp the handle firmly with both hands.
Securely hold on to the jack handle so your
hands do not slip and ensure the release valve
does not rapidly lower.
5. After removing jack from under the load, push
ram and handle sleeve down to reduce exposure
to rust and contamination.
WARNING:
USE EXTREME CAUTION
WHEN LOWERING THE JACK. THE JACK
HANDLE MAY TURN RAPIDLY. OPENING THE
RELEASE VALVE TOO FAST CAN CAUSE
THE JACK TO LOWER RAPIDLY. FAILURE TO
HEAD THESE WARNINGS COULD CAUSE
SERIOUS INJURY OR DEATH.
11. After lifting, support the load with appropriately
rated vehicle support stands before working on
the vehicle.
9. Before raising the vehicle double check and verify
the saddle is centered and also has full contact
with the lifting point.
10. Squeeze air trigger to lift until saddle contacts
load. (To stop air operation, simply release the
grip on the lift control valve.) Continue to pump
the jack to lift the vehicle to the desired height.
4. Carefully open the Release Valve by slowly
turning the handle counterclockwise. (Do not
allow bystanders around the jack or under the
load when lowering the jack.
Summary of Contents for TQ22001
Page 15: ...15 ASSEMBLY DIAGRAM...
Page 33: ...33 SCH MA DE MONTAGE...
Page 51: ...51 DIAGRAMA DE ENSAMBLAJE...
