7 - After all settings are made, press CLK key to
return unit to real time.
NOTE: When the unit is returned to the run
mode, check the load status of the current set-
ting. If it is showing OFF but should be ON,
press the ON/OFF key since the unit does not
“look back” to the setting just entered. However,
the unit will correct itself at the next scheduled
event and no further alteration will be necessary.
REVIEW/MODIFY/ADD/DELETE
REVIEW: Press SCH key continuously to review
each setting. Events will appear in the sequence
with which they were set.
MODIFY: During the review, the DAY, HR, MIN
and ON/OFF keys can all be used to modify the
settings.
ADD: New events can be added by pressing the
SCH key to advance to the next open set point.
Then set new day(s) and time.
DELETE: Press SCH key to event which you
wish to delete. Then press the HR and MIN
keys until dashes appear in place of hours and
minutes.
MANUAL OVERRIDE
Unit must be in the run mode only
Press ON/OFF key repeatedly as follows:
= Temporary OFF until the next ON
event
= Temporary ON until the next OFF
event
= Permanent ON
= Permanent OFF
To return to automatic run mode, press ON/OFF
key until appears in lower left of display.
RESET
In order to clear all memory, including real time
and schedules, insert pin into reset opening.
[
[
[
[
TORK
®
1 GROVE STREET, MT. VERNON, NY 10550 TEL: 914-664-3542
FAX: 914-664-5052
MLI-117(B)
3 - Press Minute (MIN) key to set current
minute.
Release CLK key.
TO SET SCHEDULE
For convenience, write out your desired sched-
ule on a separate paper.
1 - Press schedule (SCH) key once. The dis-
play will show all the days of the week in
numbers.
2 - Press DAY Key to set day(s)
NOTE: The following is a listing of the sets of
days which can be set:
1-2-3-4-5-6-7
MO, TU, WE, TH, FR, SA, SU
1-2-3-4-5-6
MO, TU, WE, TH, FR, SA
1-2-3-4-5
MO, TU, WE, TH, FR
6-7
SA, SU
INDIVIDUAL DAYS REPRESENTED BY A SINGLE
NUMBER
3 - Press HR key to set hour. Be sure to check
for AM or PM.
4 - Press MIN key to set minutes.
5 - Press ON/OFF key to set load status
The following appears on the display:
= ON
= OFF
6 - Press SCH key again to store the previous
entry. The display will show all days of the
week again. Press DAY, HR, and MIN keys
as above to set all other schedules up to a
total of 20 ON or OFF events.
NOTES: During settings, if you wish to erase a
partial entry, press and hold the SCH key for
about 3 seconds. If instead the SCH key is
pressed briefly, the partial entry will be erased
after 15 seconds.
To determine how many free set points are
available, press the SCH key until FR appears
on the LCD:
For example: FR 14 means there are 14 set
points still available, FR 00 means there are
none.
