4. Now press ENTER briefly and everything in the
timer memory will be erased, including real
time and date. NOTE: Unit has permanent
memory and will not be erased unless done
through procedure above.
5. Upon powering up your EWZ201 the display
will show at what frequency the unit is operat-
ing, 50 will determine 50Hz or 60 for 60Hz.
NOTE: While in the AUTO mode, if AC power is
absent, the display will show a PF (power fail-
ure) instead of the seconds scrolling up.
6. A “Lo” on the display indicates that the super
cap has run low and the unit needs to be pow-
ered with AC. A minimum of 8 hours is required
to fully charge the super cap.
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN MODE
AND THEN PRESS EVENT TO UPDATE THE
LOAD STATUS.
10
