4
STEP 4
Line up the tie down frame plate with the cab tie down frame plate, place one 1/2” -13 x 1-1/4”
GR5 bolt through each hole in the 3-hole tie down frame plate. Fasten with 1/2” GR5 serrated
nut. Hand tighten.
SEE PHOTO I & J
STEP 5
Locate the 2-1/2” X 2-1/2” X 7”(18cm) square tubing receiver and place between the side
plates on the tie down frame plate. Take two 1/2” -13 X 3-1/2” GR8 hex bolts and two 1/2”
GR5 serrated nut and place through the holes with the best angle.
SEE PHOTO J
STEP 6
Press up on the bottom of both tie down frame plates and tighten the previously installed 1/2”
fasteners from step 4.
* NOTE: THE E-BRAKE CABLE MAY RUB AGAINST THE TIE DOWN
RECEIVER. THIS IS OKAY DUE TO THE PROTECTIVE PLASTIC AND
RUBBER COATING CHEVROLET PUTS ON THEIR BRAKE LINES
FOR ADDING RECIEVER AND FOR ADJUSTMENTS, GO TO
PAGE 10
STEP 7
For passenger side installation, repeat steps 1-8 on passenger side.
STEP 8
Tighten all GR5 fasteners to 60 ft-lbs(81nm) with a Torque Wrench.
Tighten all GR8 fasteners to 60 ft-lbs(81nm) with a Torque Wrench.
* NOTE: ALL PHOTOS ARE OF DRIVERS SIDE INSTALLATION
