INSTALLATION
Install the Front Doors
Complete the following steps in the order listed:
Install the Front Door Assemblies
Assemble the Front Doors
Figure 23: Rubber trim, window, and window retainers layered to assemble the front door.
1. Push a strip of rubber trim onto the edge of the window opening on each front door. Make sure that the trim
starts at one end of the door handle mount, continues around the perimeter of the window, and ends at the
opposite side of the door handle mount. When finished, use shears or a knife to cut the excess trim.
2. Remove and discard the protective plastic film from each window.
3. On the inside of one front door, put one window on top of the rubber trim.
4. Attach one dark gray, vertical window retainer to both sides of the front door's window opening with two
sets of three M5 × 0.8 - 10 screws.
NOTICE!
To prevent window damage from over-tightening, use your fingers to tighten the screws.
Page 18
©Tormach® 2022
Specifications subject to change without notice.
tormach.com
TD10535: Installation Guide: 1100M Enclosure (0522A)
