Tormach, Inc.
P: 608.849.8381 / F: 209.885.4534
tormach.com
TECHNICAL DOCUMENT
Page 16
©Tormach® 2020. All rights reserved.
Specifications subject to change without notice.
TD10487_PCNC440_ATC_Install_1220A
5. Place a 1-2-3 block on the machine
table (see
Figure 27
). Make sure the
dowel is parallel with the 1-2-3 block
in both the Y and X direction.
If the dowel is not parallel, do one of
the following:
a.
From the ATC’s linear rail, loosen
two 5 mm socket head cap screws
(see
Figure 28
) and slowly pivot
the ATC assembly until the dowel
is parallel with the 1-2-3 block;
re-tighten 5 mm socket head cap
screws.
b.
Re-check the alignment of the
dowel in both the Y and X direction.
or
a.
From the tilt standoff, use an adjustable wrench to turn the nut and slowly pivot the ATC assembly
until the dowel is parallel with the 1-2-3 block (see
Figure 29
).
b.
Re-check the alignment of dowel in both the Y and X direction.
Repeat Step 5 until the dowel is parallel with the 1-2-3 block.
6. Remove the 1-2-3 block from the machine table.
Figure 29
Figure 28
Figure 27
