Tormach, Inc.
P: 608.849.8381 / F: 209.885.4534
tormach.com
TECHNICAL DOCUMENT
Page 6
©Tormach® 2020. All rights reserved.
Specifications subject to change without notice.
TD10487_PCNC440_ATC_Install_1220A
Mount the Automatic Tool Changer
1.
Identify four standoffs included with this kit
(see
Figure 5
):
•
One fixed standoff
NOTE:
The fixed standoff uses a
threadlocker to hold the nut in place.
•
One tilt standoff
•
Two adjustable standoffs
The standoffs mount the ATC to the mill’s
Z-column.
2.
Arrange the four standoffs next to each other
(see
Figure 5
).
3. Loosen or tighten the nut on the two adjustable
standoffs until they are the same length as the
fixed standoff (see
Figure 5
).
4.
On the mill’s Z-column, use an adjustable wrench to install the four standoffs in the order shown in
Figure 6
.
Securely tighten the standoffs to the mill’s Z-column.
5. From each standoff, remove the flange nut and the washer (see
Figure 7
).
Set aside all flange nuts and washers.
Figure 6
Tilt
Adjustable
Adjustable
Fixed
Figure 5
Tilt
Adjustable
Adjustable
Fixed
Figure 7