Tormach, Inc.
P: 608.849.8381 / F: 209.885.4534
tormach.com
TECHNICAL DOCUMENT
Page 12
©Tormach® 2017. All rights reserved.
Specifications subject to change without notice.
TD10422_SmartCool_Install_0417A
Other Configurations
Using a Fog Buster as a secondary coolant source requires removing the auxiliary solenoid from the MultiCoolant
Module and installing it on the Fog Buster. In this configuration, power is supplied to the Fog Buster through the
SmartCool’s Control Module.
1.
Unplug Fog Buster.
2.
Remove solenoid and power cord from Fog
Buster (see
Figure 29
) and set aside; keep for
future use.
3.
Remove auxiliary solenoid from MultiCoolant Module (see
Figure 30
); set aside remaining parts from
MultiCoolant Module and keep for future use.
4.
Install MultiCoolant’s auxiliary solenoid in place of solenoid and power cord removed from Fog Buster in
Step 2 (see
Figure 31
).
5.
Connect MultiCoolant Module to middle 3.5 mm jack on Control Module (see
Figure 28
).
Figure 29
Remove
Figure 31
MultiCoolant
Auxiliary
Solenoid
Figure 30
MultiCoolant
Module
