16
2.Press the push button (17) of
up/down of the brushes base
to lower the brushes. Once
that it is lowered, the brushes
begin to turn. The blinking
signal lamp (16) indicates that
the brushes base is lowering
or raising (the signal remains
on when the brushes base is
in working position), while the
signal lamp (18) signals that
the brushes are turning.
3.Press the switch (19) to
open the solenoid valve and
permit the detergent solution
to lower onto the brushes. The
signal lamp (20) will come on,
to indicate that the solenoid
valve is open.
TO CARRY OUT THE
FUNCTION OF ONLY DRYING:
1.Press the push button (11)
of up/down squeegee to lower
the squeegee. The signal
lamp (12) indicates that the
squeegee is lowering or lifting
(the signal remains on when
the squeegee is in working
position).
2.Press the switch (9) of the
suction motor to start the
suction system. The signal
lamp (8) indicates that the
machine is drying.
Position the selector (28)
forward to choose the forward
drive.
Adjust the movement speed in
forward with the push button
(21) (see under paragraph
"FORWARD AND BACKWARD
MOVEMENT”).
Pressing the accelerator
pedal, the machine begins to
proceed forward and to work
according to the set functions.
In manual mode every
function of the machine has
to be activated or deactivated
manually.
ATTENTION:
FL
OW ADJUSTMENT OF THE
DETERGENT SOLUTION
To adjust the detergent
solution quantity that flows
down onto the brushes it
is necessary to act upon
the solution valve knob (27)
placed on the right of the
steering column, rotating
counterclockwise to increase it
and clockwise to reduce it up
to close the flow.
It is convenient to adjust the
flow during working operation
and at each adjustment of the
brushes pressure.
WORKING ADJUSTMENTS
Both in automatic as in manual
mode, during the first metres
check:
1.that the squeegee
adjustment guarantees
a perfect drying result
(see under paragraph
“ADJUSTMENT OF THE
SQUEEGEE”).
2.that the adjustment of the
detergent solution flow is
sufficient to wet the floor
uniformly avoiding the leakage
of detergent from the splash
guards (see under paragraph
“FLOW ADJUSTMENT OF THE
DETERGENT SOLUTION”).
3.that the brushes pressure
permits an efficient washing
action in function of the dirt
and the speed (see under
paragraph “ADJUSTMENT OF
THE BRUSHES PRESSURE”).
ADJUSTMENT OF THE
BRUSHES PRESSURE
Both in automatic and in
manual mode it is possible
through the selector (10)
to adjust the brushes
pressure on the floor in eight
established levels. During the
operation, we can visualize
on the display (1) the value
in percentage of the electric
absorption of the brushes
motor by pressing the button
(14). The adjustment occurs in
this way both in automatic and
in manual mode.
The presence on the display
(1) of a blinking warning from
P2 to P8 indicates that the
pressure level set determines
an overload of the brushes
motor. It is therefore necessary
to reduce the pressure up to
the level where the blinking
warning stops.
ATTENTION:
