Usage:
Fan operation:
Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan location:
Place the fan in the area of the room that will
provide proper fan cooling.
Fan connection:
Plug fan directly into 120 volt A.C., 60 Hz wall
outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or fan.
Note:
To prevent overloading a circuit, do not plug the fan into a
circuit that is servicing other electrical needs.
Speed control:
Select air speed by setting switch to either
low-medial-high-off.
•
OFF
•
LOW
•
MED
•
HIGH
Care and Maintenance
Cleaning:
CAUTION-Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Replace front grille before fan use. Allow fan to dry
completely before use. Periodic grille cleaning with a vacuum will
prevent dust build up. The motor is sealed and does not require
any interior maintenance, cleaning or lubrication.
Maintenance:
The Internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair:
DO NOT OPERATE THE FAN WITHOUT THE GRILLE IN
PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR
BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage of the fan. Coil and tie
the power cord to avoid damage during storage.
TO ADJUST AIRFLOW UPWARD
OR DOWNWARD
Loose pivot
bolt
for adjusting the desired tilt angle of
fan head, and
fix it again.
SETTING OSCILLATING MODE
1.
To oscillate the fan, loosen the thumb screw on
the oscillation rod and move to the end of the
clutch plate. Tighten the screw to lock the position.
(See Figure A.)
2.
To stop the oscillation, loosen the thumb screw on
the oscillation rod and move to the center of the
clutch plate. Tighten the screw again to lock the
position. (See Figure
B
.)
。
