7
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
•
DO NOT
use to clean up any burning or lighted
materials such as cigarettes, matches, ashes, or
other combustible objects.
• Only use the machine on firm, level surfaces.
DO NOT
use the machine on gradient or slope of
more that 2%.
•
CAUTION
–This machine is for dry, indoor use
only and should not be used or stored outdoors
or in wet conditions.
Protect from rain.
• Take care when using this machine near the top
of stairs to avoid loss of balance.
•
DO NOT
cover the machine when in use.
•
DO NOT
run the machine dry as this
could damage the floor surface and/or the
machine itself.
•
DO NOT
leave the machine running unattended.
• Keep hair, loose clothing, hands, feet, and all
other parts of the body away from openings and
moving parts. Do not put hands under base as
rotating parts can cause injury.
•
DO NOT
put any object into openings.
DO NOT
use with any opening blocked. Keep free of dust,
debris and anything that may reduce airflow.
•
DO NOT
use volatile or combustible solvents
(e.g., diesel, petrol, PA, trichloromethane) nor
any corrosive, toxic, or highly irritant substance
to wash floors, even if diluted. In the event of
accidental contact with any such substances
(e.g., due to spills) follow the decontamination
procedures in force at the user site. If in any
doubt about the condition of the machine,
contact Tornado or the dealer/agent who
supplied the machine.
•
DO NOT
leave the machine unattended when
plugged in. Unplug from outlet when not in use
and before changing brushes or attempting any
maintenance or adjustment.
•
DO NOT
fill the machine with water hotter than
135°F (57°C).
• When used on escalators, ensure the machine
is positioned at the bottom of the escalator with
the escalator moving towards the operator.
•
DO NOT
pull or carry by cord, use cord as a
handle, close a door on cord, or pull cord around
sharp edges on corners.
•
DO NOT
run machine over cord. Keep cord away
from heated surfaces.
•
DO NOT
unplug by pulling on cord. To unplug,
grasp the plug, not the cord. Do not handle plug
or machine with wet hands. Turn off all controls
before unplugging.
• Connect only to a properly grounded outlet. See
grounding instructions.
• Use care to keep electrical supply cable from
contacting moving parts such as floor brushes.
• Make sure voltage and frequency at the wall
receptacle correspond with that indicated on
nameplate before plugging in machine.
• The machine must be kept clean and in good
condition with regular inspections of the power
cord and plug for signs of any damage. If any
parts are damaged, they shall only be replaced
by an approved part by the manufacturer, its
service agent or a similar qualified person in
order to avoid a hazard.
• Only replace the power cord with original
OEM equipment.
Summary of Contents for TE310-G15-U
Page 17: ...17 NOTES...