12
The capacity of the detergent solution tank
is indicated in the technical data. Open the
screw plug (1) placed in the rear left part of the
machine and fill the detergent solution tank
with clean water at a maximum temperature
of 122°F (50°C). Add the liquid detergent in
the percentage and conditions recommended
by the manufacturer. To avoid excessive foam
presence, which could cause problems to the
suction motor, use the minimum percentage of
detergent. Screw down the plug to close the
tank.
Always use low foam detergent. To avoid foam
presence, before starting working operation,
introduce into the recovery tank a minimum
quantity of anti-foam product. Never use pure
acid.
FLOOR CLEANING
CONNECTION OF THE BATTERIES TO THE
MACHINE
Plug in the batteries connector (1) to the
machine connector (2), placed in the rear part
of the machine
STARTING OF THE MACHINE
1. Press the switch ignition 1/0 (1).
2. Check the charge level on the display or
on the signal lamp battery charge level.
3. Press the brush motor switch (3).
4. Press the suction motor switch (4).
5. Press the solenoid valve switch (5).
6. Acting upon the brush base lifting pedal
(9) lower the brush base.
8. Acting upon the solution valve lever (7)
open and adjust the solution detergent
flow. The water starts to flow automatically
when the brush motor is activated. On the
instrument board the indicator of the
solenoid valve switch (5) will turn on.
9. Activating the levers drive control (6) the
machine will start moving, the brush
starts to rotate, the solenoid valve activates the
water flow and the squeegee will start drying
the floor.
10. During the first meters check that the
detergent solution flow is appropriate and that
the squeegee adjustment guarantees a perfect
drying action.
Summary of Contents for TS120-S53-U
Page 20: ...20...
