tornos DECO 10 Headstock Revision, Description - Procedures

TT5501 - DECO 10 Headstock Revision

Chap. 4.2 / 11

TT5501 en  -  12/04

25. Place the headstock on the press with the tool ref.

40 to mount the ”Seeger” ring (640), with the gap
of the ring in the middle of the refill plug.

∆

  Caution !

Install in place without forcing to prevent
damaging the secondary piston’s gaskets.

640

26. Adjust the clearance of the spindle by loosening

the 4 adjusting screws (140) section J - J until at
the stop without forcing by ”alternately tightening
the screws diagonally”.

27. Tap on the body with a nylon mallet to install the

assembly.

28. Tighten 1/4 turn and reloosen 1/8 turn.

29. Tighten the 4 clamping screws with brass wire.

30. Tap on the body with a nylon mallet and check.

∆

  Attention !

The spindle must turn freely without binding
or wobbling.

31. Mount the tubing (080) and the pivot axis (090)

”lightly greased” section G - G.
Using the nylon mallet, tap softly to not damage
the solenoid valve.
Tighten the sealing plug (100) with its gasket
using the 2 screws (530).

32. Place the thrust tube (260), grease the threads

and tighten it in the headstock.

⇒

Note:
Use the grease Mobil 28.