LOGBOOK − M
ULTI
DECO
Chap. 9.2.3 / 14
300428 en − 03/07
9.
PERIODICAL MAINTENANCE & GREASING
.
Attention !
− The maintenance plan must be complied with.
− For machines equipped with a barguide, the interior red tubes must absolutely be lubricated
before the introduction of the bars.
TORNOS SA declines any liability for damages caused by the disregard of these rules.
9.1
DAILY MAINTENANCE
What to do ?
Remarks
Check the sieve and the suction filter
... of the main coolant tank
Clean the sieve and the suction filter
... of the main coolant tank
9.1.1 Cyclic lubrication
Drawing: position 4
− Check the level and top up, every 24 hours
Both circuits − cyclic and recirculation − are pro-
vided with an alarm with display on the screen
9.2
EVERY 250 HOURS
Δ
Attention ! The number of hours means hours of machine operation.
⇒
Refer to positions of floor plan above.
What to do ?
Remarks
9.2.1 Greasing of clamping rings and cams
Drawing: position 1
− Grease carefully all the cams, the clamping rings
and the toggles...
...according to greasing plan of the machine by
means of a brush and the appropriate grease.
9.2.2 Lubrication of gearbox
Drawing: position 2
− Check the oil level by the level indicator located in
the group on the back of the machine.
9.2.3 Tool coolant
Drawing: position 3
− Check the coolant level...
...by the level indicator located on the tank.
− Top up the coolant
−
Clean the flowrate sensor
See instruction: OPERATION / MAINTENANCE
Summary of Contents for MultiDeco 20/6
