Cutting Unit Safety
•
The cutting unit is only a complete machine when
installed on a traction unit. Read the traction
unit
Operator’s Manual
carefully for complete
instructions on the safe use of the machine.
•
Stop the machine, remove the key (if equipped),
lower the cutting unit, and wait for all movement to
stop before inspecting the attachment after striking
an object or if there is an abnormal vibration in
the machine. Make all necessary repairs before
resuming operation.
•
Keep all parts in good working condition and all
hardware tightened. Replace all worn or damaged
decals.
•
Use only accessories, attachments, and
replacement parts approved by Toro.
Blade Safety
A worn or damaged blade can break, and a piece of
the blade could be thrown toward you or bystanders,
resulting in serious personal injury or death.
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades.
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or missing.
decal134-3688
134-3688
1.
Height of cut
3.
Mounting hole locations
2.
Do not use the lower mounting hole.
decal117-4979
117-4979
1.
Entanglement hazard, belt—keep away from moving parts;
keep all guards and shields in place.
decal58-6520
58-6520
1.
Grease
4
Summary of Contents for 02835
Page 27: ...Notes ...
Page 28: ...Notes ...