g319436
Figure 9
1.
Castor bolt
4.
Bearing spacer
2.
Castor fork
5.
Large locknut
3.
Bearing
2.
Assemble each caster arm to the cutting unit
with 6 carriage bolts (M10) and 6 locknuts (M10)
as shown in
; torque the locknuts to 47
to 57 N∙m (34 to 42 ft-lb).
g314698
Figure 10
Left side shown
1.
Carriage bolt
3.
Caster arm
2.
Locknut
3.
Assemble the casters to the cutting unit with a
shim on both sides of the caster shaft hub as
shown in
Note:
You can adjust the height-of-cut setting
by changing the amount of spacers on either
side of the caster shaft hub; refer to
the Height of Cut (page 13)
.
g319438
Figure 11
1.
Tensioning cap
4.
Caster shaft hub
2.
HoC spacers
5.
Caster wheel shaft
3.
Shim
4.
Ensure that the deck is level; move the deck to
a level surface and place a level horizontally
across the top of the deck.
5.
If the deck is not level, position the shims on the
caster shaft accordingly until it is level.
8
Summary of Contents for 02835
Page 27: ...Notes ...
Page 28: ...Notes ...