Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
Cutting unit
1
Inspect the cutting unit
2
No parts required
–
Use the kickstand when tipping the
cutting unit
3
No parts required
–
Adjust the rear shield
4
No parts required
–
Mount the counter weights
5
Tipper roller kit (not included)
1
Install the optional tipper roller kit
6
Fixed plate kit (not included)
1
Install the Optional Fixed Plate Kit
Media and Additional Parts
Description
Qty.
Use
Parts Catalog
1
Use to reference part numbers
Operator's Manual
1
Review the manual and save in an appropriate place
Certificate of Compliance
1
CE compliance
O-ring
1
Use when mounting reel motor to cutting unit
Screws
2
Use to mount reel motor to cutting unit
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Inspection
Parts needed for this procedure:
1
Cutting unit
Procedure
After the cutting unit is removed from the box, inspect the
following:
1.
Check each end of the reel for grease. Grease should
be visibly evident in the reel bearings and internal
splines of the reel shaft.
2.
Ensure that all nuts and bolts are securely tightened.
3.
Make sure the carrier frame suspension operates freely
and does not bind when moved back and forth.
2
Cutting Unit Kickstand
No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand (supplied with the traction unit) to make sure the
nuts on the back end of the bedbar adjusting screws are not
resting on the work surface (Figure 3).
4
