Figure 3
1.
Cutting unit kickstand
3
Adjusting the Rear Shield
No Parts Required
Procedure
Under most conditions, best dispersion is attained when the
rear shield is closed (front discharge). When conditions are
heavy or wet, rear shield may be opened.
To open the rear shield (Figure 4), loosen the cap screw
securing the shield to the left side plate, rotate the shield to
the open position and tighten the cap screw.
Figure 4
1.
Rear shield
2.
Cap screw
4
Mount the Counter Weights
No Parts Required
Procedure
All cutting units are shipped with the counter weight mounted
to the left end of the cutting unit. Use the following diagram
to determine the position of the counter weights and reel
motors.
Figure 5
1.
On the #3 cutting unit, remove the 2 cap screws
securing the counter weight to the left end of the
cutting unit. Remove the counter weight (Figure 6).
5
