Assembling the Groomer Reel (continued)
4. Using through holes in shaft to prevent shaft from rotating, tighten second
lock nut from
42 to 48 N·m (31 to 35 in-lb)
. After tightening lock nut, spacers
should not be free to rotate and groomer blades should be centered on shaft.
5. If groomer reel is equipped with broomer kit:
A. Loosen the groomer blade retaining nuts on each end of the groomer
shaft.
g220499
Figure 216
1.
Groomer reel
3.
Blade
2.
Broomer strap (4 each)
4.
Brush
B. Slide a brush into each groove around the full length of the groomer reel
(
). Make sure that the brushes are seated in groomer blade
slots (
).
IMPORTANT
The straps must be wrapped around the groomer blade and brush
assembly in the correct direction.
C. Loosely wrap the straps around the groomer reel shaft and brushes as
shown (
). Straps should be positioned in the pre-cut notches
of each brush and at the following locations on the broomer shaft:
18” reels - between blades 2-3, 11-12, 21-22 and 30-31.
22” reels - between blades 2-3, 14-15, 26-27 and 38-39.
Position the broomer brushes properly in the blade slots, and tighten the
groomer blade-retaining nuts from
42 to 48 N·m (31 to 35 ft-lb)
.
D. While holding strap buckle in place, pull straps tight into the pre-cut
notches of each brush.
E. Cut off strap extension approximately 6mm (1/4 in) beyond retainer and
fold the excess strap over the buckle (
).
6. Install O-ring on non-drive end of groomer shaft.
7. Install groomer reel back on cutting unit (refer to
(page 9–16)
).
Universal Groomer (Optional): Service and Repairs
Page 9–18
Reelmaster
®
3100-D/3105-D
20252SL Rev A
Summary of Contents for 03200 Reelmaster 3100-D
