Installing the Rear Roller (
) (continued)
carriage screws and flange nuts to retain bracket in position. Do not fully
tighten flange nuts.
3. Slide rear roller shaft into the rear roller bracket attached to the cutting unit.
Slide second rear roller bracket onto the other end of roller shaft. Secure
second roller bracket and shims to cutting unit side plate with two (2) carriage
screws and flange nuts. Do not fully tighten flange nuts.
4. Center rear roller to the cutting reel and secure in place by tightening four
(4) flange nuts.
5. Lubricate the rear roller.
6. Adjust the cutting unit; refer to
Cutting Unit Operator’s Manual
.
Reelmaster
®
3100-D/3105-D
Page 8–35
DPA Cutting Units: Service and Repairs
20252SL Rev A
Summary of Contents for 03200 Reelmaster 3100-D
