g019284
1
1
Figure 9
1.
Hose guides (each must lean toward the center cutting unit)
Note:
When installing or removing the cutting
units, make sure the hairpin cotter is installed in
the spring rod hole next to the rod bracket. When
not installing or removing the cutting units, the
hairpin cotter must be installed in the hole in the
end of the rod.
6.
Lower all the lift arms completely.
7.
Remove the snapper pin and the cap from the lift arm
pivot yoke (Figure 10).
Figure 10
1.
Snapper pin
2.
Cap
8.
For the front cutting units, slide a cutting unit under
the lift arm while inserting the carrier frame shaft up
into the lift arm pivot yoke (Figure 11).
Figure 11
1.
Lift arm
3.
Lift arm pivot yoke
2.
Carrier frame shaft
9.
Use the following procedure on the rear cutting units
when the height of cut is above 3/4 inch.
A.
Remove the lynch pin and washer securing the lift
arm pivot shaft to the lift arm and slide the lift
arm pivot shaft out of the lift arm (Figure 12).
Figure 12
1.
Lift arm pivot shaft lynch pin and washer
13
Summary of Contents for 03673
Page 46: ...Notes 46 ...
Page 47: ...Notes 47 ...
