17
4. Disassemble the cone nut from the shoulder bolt
securing the bearing housing to the sideplate, remove
the Belleville washer and bolt, and slide the bearing
housing off of the reel shaft (Fig. 30).
5. Remove the cover from the drive housing and remove
the drive belt from the housing (Fig. 30).
1
2
Figure 30
1.
Drive housing (cover
removed)
2.
Drive Belt
6. Remove the reel capscrew, toothed washer, and pulley
washer from the reel shaft (Fig. 31).
Note: The capscrew is assembled with a thread locking
compound.
1
2
3
4
5
6
7
Figure 31
1.
Reel capscrew
2.
Pulley washer
3.
Driven pulley
4.
Drive housing
5.
Adjusting handle
assembly
6.
Woodruff key
7.
Drive housing fasteners
7. Using a puller, remove the driven pulley from the reel
shaft (Fig. 31). Remove the woodruff key from the reel
shaft.
8. Remove the adjustment assembly and cone nut,
Belleville washer, and shoulder bolt securing the
housing to the sideplate (Fig. 31). Remove the
housing.
9. Slide the reel assembly out of the slots in the
sideplates.
10. To remove the bearing and seals from the drive
housing, remove the retaining ring from the inside of
the housing. Pry the outer seal out of the belt drive
case side. Press the bearing and rear seal out from the
outer side of the housing.
11. To remove the bearing and seal from the bearing
housing, remove the dust cap (Fig. 28) and press the
bearing and seal out of the housing.
