Product Overview
Specifications
Tractors
These cutting units will mount on the Reelmaster 6500 & 6700 Traction Units.
Height of Cut
Cutting height is adjusted on the front roller by two vertical screws and held by two locking
cap screws
Height Of Cut Range
Standard bench height of cut range is .250 inch (3 mm) to 1.00 inch (25 mm). Bench height
of cut range with the High Height of Cut Kit installed is 1.00 inch (25 mm) to 2.00 inches
(51 mm). Effective HOC may vary depending on turf conditions, type of bedknife, rollers
and attachments installed.
Reel Weldment
Reels are 7 inches (18 cm.) in diameter, 22 inches (56 cm.) in length. High strength low
alloy steel blades are thru hardened and impact resistant.
Reel Bearings
Two double row self-aligning ball bearings, press fit onto reel shaft.
Power Attachment
The reel motors feature quick disconnect for removal or installation onto cutting unit. The
cutting units can be driven from either end.
Frame
Die cast aluminum cross member with three bolt-on die-cast aluminum side plates.
Rollers
The front roller is a 3 inch (76 mm) diameter plastic Wiehle roller. The rear roller is a 3.0 inch
(76 mm) diameter steel full roller.
Bedknife
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 8 screws. The EdgeMaxt® bedknife is standard.
Bedknife Adjustment
Dual screw adjustment to the reel; detents corresponding to .0009 inch (.023 mm) bedknife
movement for each indexed position.
Grass Shield
Adjustable rear shield with optional adjustable cut-off bar to improve grass discharge from
reel in wet conditions.
Counterweight
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
Maximum Reel Speed
1650 RPM.
Weight
8 Blade 147 lb. (67 kg) 11 Blade 151 lb. (69 kg)
10
