Greensmaster Flex 18/21
Page 6 – 5
Chassis and Controls
Handle Removal
1. Park machine on a level surface. Make sure engine
is OFF. Remove spark plug wire from the engine spark
plug.
2. Note location of cable ties used to secure control
cables. Remove cable ties.
3. Disconnect:
A. Reel control and traction cables from gearbox
(see Cable Replacement in this section).
B. Parking brake cable from brake bracket assem-
bly (see Cable Replacement in this section).
C. Throttle cable from engine (see Throttle Cable
Replacement in this section).
D. Interlock switch wire connection.
4. Loosen and remove flange nut from cap screw on
each end of the handle (Fig. 3).
5. Remove handle from frame.
Handle Installation
1. Slide handle ends through the holes in the handle
arms with grommets. Install handle to the frame using
cap screw, pivot pin and flange nut on each side.
2. Attach and adjust:
A. Reel control, traction and parking brake cables
(see Cable Replacement in this section).
B. Throttle cable (see Throttle Cable Replacement
in this section).
C. Interlock switch wire connection.
3. Secure cables to handle with cable ties.
4. Attach spark plug wire to spark plug.
1. Handle
end
2. Handle arm w/grommet
3. Hairpin
cotter
4. Ring
pin
5. Cap
screw
6. Pivot
pin
Figure 2
4
2
5
6
3
1
1. Handle
2. Handle
arm
3. Handle
grommet
4. Handle support spacer
5. Pivot
pin
6. Flange
nut
7. Cap
screw
8. Ring
pin
9. Hairpin
cotter
Figure 3
3
2
4
5
6
9
8
7
1
FRONT
RIGHT
Chassis and
Controls
Summary of Contents for 04022 Greensmaster Flex 21
