Use the following table and Figure 58 to set the
rate of clip.
Clip
(Refer to Figure 58 for pulley locations.)
Drive pulley number of
teeth
Driven pulley number
of teeth
11 Blade Clip
8 Blade Clip
27
22
.14 inches (standard)
.19 inches
22
22
.16 inches
.24 inches
22
27
.21 inches
.29 inches
The reel is shipped with one 27 tooth and one
22 tooth pulley. To get a .16 inch clip, you must
purchase a 22 tooth pulley. The clip can only be
changed on the reel drive (Figure 58). Do not
change the drive ratio on the gearbox pulleys.
Figure 58
1. Reel drive belt
3. Driven pulley
2. Drive pulley
Servicing the Bedbar
Removing the Bedbar
1. Turn the bedbar adjuster screw,
counterclockwise, to back the bedknife
away from reel (Figure 59).
Figure 59
1. Bedbar adjusting screw
4. Jam nut
2. Spring tension nut
5. Bedbar bolt
3. Bedbar
2. Back out the spring tension nut, until the
washer is no longer tensioned against the
bedbar (Figure 60).
3. On each side of the machine, loosen the jam
nut securing the bedbar bolt (Figure 60).
Figure 60
1. Bedbar bolt
2. Nut
4. Remove each bedbar bolt allowing bedbar to be
pulled downward and removed from machine.
Account for 2 nylon and 2 stamped steel
washers on each end of bedbar (Figure 61).
37
