Figure 32
Main Harness P23 Connector and EZ-Turn (Slow-in-Turn) Sensor Pin Identification
Pass
12 Vdc measured good at the listed location. Go to step 4.4.
Fail
12 Vdc did not measure good at the listed location. Repair or replace worn or
damaged parts as required. Go to
Returning the Equipment to Service (page 19)
and
follow the steps listed.
Step 4.4:
Check the wire harness for continuity and verify that there are
no short conditions.
Note:
Inspect the main wire harness while checking the items in the following steps. Refer to
Harnesses and Component Connector Assemblies (page 13)
.
Note:
Troubleshoot 1 circuit or component at a time. Disconnect or isolate each component or wire harness section
from the system before testing.
Disconnect the battery pack. Refer to
Disconnecting the Battery Pack (page 17)
.
Step 4.4.1:
Check the wire harness for continuity and verify that there
are no short conditions for the InfoCenter.
1.
Check for continuity between the following pairs of locations:
Location
Harness
Connector
Pin
Connector Graphic
1
Main
P01
5
1
12
7
6
2
Main
P17
2
1
3
4
6
27