Figure 20
1.
Reel drive cover plug
2. Insert a 18 mm socket onto hex flange nut on left
end of reel shaft.
3. Backlap according to the procedure in the Toro
Sharpening Reel and Rotary Mowers Manual, Form
No. 80-300 PT.
DANGER
Contact with the reel or other moving parts can
result in personal injury.
•
Stay away from the reel while backlapping.
•
Never use a short handled paint brush for
backlapping. Part No. 29-9100 Handle
assembly complete or individual parts are
available from your local Authorized Toro
Distributor.
Note:
For a better cutting edge, run a file across
the front face of the bedknife when the lapping
operation is completed. This will remove any burrs
or rough edges that may have built up on the cutting
edge.
4. Reinstall plug when backlap operation is completed.
11
