Greensmaster 3300/3400
DPA Cutting Units
Page 8 -- 2
Specifications
Figure 1
Frame Construction:
Precision machined die cast alu-
minum cross member with two (2) bolt--on cast alumi-
num side plates.
Reel Construction:
Reels are 21 inches (53.3 cm) in
length and 5 inch (12.7 cm) in diameter. High strength,
low alloy steel blades are thru hardened and impact re-
sistant. Reels are available in 8, 11 and 14 blade config-
urations.
Reel Bearings:
Two (2) sealed stainless steel, deep
groove ball bearings support the reel shaft with inboard
seal for protection.
Reel Drive:
The reel weldment shaft is a 1.350 inch
(34.3 mm) diameter tube with a drive insert threaded
into the left end. The reel drive insert has an internal
eight (8) tooth spline.
Height--of--Cut (HOC):
Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
Bedknife:
Replaceable, single edged, high carbon
steel bedknife is fastened to a machined cast iron bed-
bar with thirteen (13) screws. Optional bedknives are
available.
Bedknife Adjustment:
Dual screw adjustment to the
reel; detents corresponding to 0.0007 inch (0.018 mm)
bedknife movement for each indexed position.
Front and Rear Rollers:
Greaseless through--shaft
front and rear rollers are used with the TriFlex DPA cut-
ting units. All greens rollers use the same heavy duty ball
bearing and seal package.
Counterbalance Weight:
A cast iron weight mounted
opposite to the hydraulic reel motor balances the cutting
unit.
Cutting Unit Weight:
21” Reel, 8 Blade
71 lb (32 kg)
21” Reel, 11 Blade
74 lb (34 kg)
21” Reel, 14 Blade
77 lb (35 kg)
Options:
Refer to Cutting Unit Operator’s Manual for available op-
tions for your Greensmaster DPA cutting unit.
Summary of Contents for 04510 Greensmaster 3300 TriFlex
