Greensmaster 3300/3400
DPA Cutting Units
Page 8 -- 12
Service and Repairs
Backlapping
DANGER
TO AVOID PERSONAL INJURY OR DEATH:
D
Never place hands or feet in the reel area
while the engine is running.
D
When backlapping, run engine at idle speed
only.
D
While backlapping, the reels may stall and
then restart.
D
Do not attempt to restart reels by hand or
foot.
D
Do not adjust reels while the engine is
running.
D
If a reel stalls, stop engine before attempting
to clear the reel.
D
Reel motors are connected in series: rotating
one motor causes rotation in other motors.
NOTE:
Additional instructions and procedures on
backlapping are available in the Toro General Service
Training Book, Reel Mower Basics (part no. 09168SL).
1. Position the machine on a level surface, lower the
cutting units, stop the engine and engage the parking
brake.
2. Remove the console cover to expose controls.
3. Locate the reel speed control and backlap lever on
the hydraulic mow manifold (Figs. 11 and 12). Rotate the
reel speed control to position “1” and the backlap lever
to the R (backlap) position.
4. Make initial reel to bedknife adjustments appropriate
for backlapping on all cutting units which are to be back-
lapped.
5. Start engine and run at
idle speed
.
6. Use joystick on the control console to engage the
cutting units.
IMPORTANT: To prevent damage to the reel, do not
rotate the backlap lever from the backlap position to
the mow position while the engine is running.
7. Apply lapping compound with a long handle brush
(see Special Tools in this chapter) (Fig. 13). Never use
a short handled brush to apply lapping compound.
1. Mow manifold
2. Reel speed control
Figure 11
1
2
1. Backlap lever (forward)
2. Backlap lever (backlap)
Figure 12
2
1
Figure 13
1. Long Handle Brush
1
Summary of Contents for 04510 Greensmaster 3300 TriFlex
