Product Overview
Specifications.
Tractors
These cutting units will mount on the Greensmaster 3300 and 3400 Traction Units.
Height of Cut
Cutting height is adjusted on the front roller by two vertical screws and held by two locking
cap screws
Height Of Cut Range
Standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch). Bench
height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch) to 25 mm
(1.00 inch). Effective height of cut may vary depending on turf conditions, type of bedknife,
rollers, and attachments installed
Reel Bearings
Two sealed stainless steel, deep groove ball bearings.
Rollers
The rear roller is a 5.1 cm (2 inch) diameter steel full roller
Bedknife
Replaceable single edged, high carbon steel bedknife is fastened to a machined cast iron
bedbar with 13 screws.
Bedknife Adjustment
Dual screw adjustment to the reel; detents corresponding to 0.018 mm (0.0007 inch)
bedknife movement for each indexed position.
Grass Shield
Non-adjustable shield with adjustable cut-off bar to improve grass discharge from reel in
wet conditions.
Counterweight
A cast iron weight mounted opposite to the drive motor balances the cutting unit.
Net Weight
8 Blade—32 kg (71 lb), 11 Blade—34 kg (74 lb), 14 Blade—35 kg (77 lb)
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
8
