5
Installing the Drive-Side
Bracket and the Drive
Housing to the Cutting Unit
Units With a Universal Groomer
Drive Kit Only
Parts needed for this procedure:
2
Flange nut (5/16 inch)
2
Flange-head bolt (5/16 x 1 inch)
1
Retaining ring
Procedure
1.
For units with groomers installed, remove and
retain the cap.
g283369
Figure 13
1.
Cap
2.
Secure the assembled drive-side bracket
and drive housing to the cutting unit with 2
flange-head bolts (5/16 x 1 inch), 2 flange nuts
(5/16 inch), and a retaining ring as shown in
Note:
This step applies to units both with or
without a groomer.
g032460
Figure 14
1.
Flange nut (5/16 inch)
3.
Retaining ring
2.
Flange-head bolt (5/16 x
1 inch)
6
Installing the Brush
Assembly
Parts needed for this procedure:
1
Brush assembly
1
Bracket assembly (non-drive side)
1
Bearing cover
2
Hex-socket screw
2
Locknut
1
Small retaining ring
1
Flocked seal
Procedure
1.
Use 2 hex-socket screws (1/4 x 3/4 inch) and 2
locknuts (1/4 inch) to install the bearing cover
onto the bracket assembly on the non-drive side
(
).
7
Summary of Contents for 04650
Page 14: ...Notes...
Page 16: ......
