Adjustments
Traction Bail Proximity Sensor
g349622
Figure 46
1.
Clutch bail link
3.
Jam nuts
2.
Proximity sensor
Adjusting the Traction Bail Proximity Sensor
1. Park the machine on a level surface. Ensure that the key switch is in OFF
position and the traction control is in NEUTRAL.
2. Disconnect the battery pack; refer to
Connecting the Lithium Battery Pack
(page 5–3)
.
3. Remove the bolts and washers that secures the control cover to the handle
assembly. Remove the control cover from the machine.
4. Get access to the proximity sensor. Pull up and release the traction bail.
5. When the bail is open, adjust the proximity sensor gap to
2.3 to 3.8 mm
(0.09 to 0.15 in)
.
6. If the clearance is incorrect, loosen the proximity sensor jam nuts and adjust
the clearance.
7. After achieving the required clearance, torque tighten the proximity sensor
jam nuts to
18.3 to 22.3 N·m (13.5 to 16.5 ft-lb)
.
8. Install the control cover to the handle assembly and secure with bolts and
washers.
9. Connect the battery pack; refer to
Connecting the Lithium Battery Pack
(page 5–3)
.
Electrical System: Adjustments
Page 5–20
Greensmaster
®
e1021/e1026
20246SL Rev A
Summary of Contents for 04831
