Testing the Key Switch (continued)
g190999
Figure 58
5. With the use of a multimeter (ohms setting), test the switch functions to
determine if continuity exists between the various terminals for each switch
position. The switch terminals are marked as shown in
. The
circuitry of the key switch is shown in the
Circuit Logic Table (page 5–32)
.
Check the continuity between the switch terminals.
Circuit Logic Table
Switch Position
Circuits
OFF
None
RUN
B+C+F, D+E
START
A+B+C
6. Replace the key switch if necessary.
7. After you complete the testing, connect the wire harness electrical connector
to the key switch.
8. Install the InfoCenter mount to the handle; refer to
.
9. Connect the battery pack; refer to
Connecting the Lithium Battery Pack
(page 5–3)
.
Electrical System: Testing the Electrical Components
Page 5–32
Greensmaster
®
e1021/e1026
20246SL Rev A
Summary of Contents for 04831
