Cutting Unit Assembly
g261511
Figure 104
1.
Cutting unit assembly
4.
Dowel pin (4 each)
2.
Reel drive assembly
5.
Frame assembly
3.
Socket head screw (4 each)
Removing the Cutting Unit Assembly
Note:
Refer to
during this procedure.
1. Park the machine on a level surface on the traction drum. Ensure that the
engine is OFF and the traction control is in NEUTRAL.
2. Remove the spark plug wire from the engine spark plug.
3. Slide the telescopic coupler on the reel drive assembly (2) from the
transmission drive shaft.
Note:
If necessary, remove the reel drive assembly (2) from the cutting unit
assembly (1); refer to
Removing the Reel Drive Assembly (page 4–7)
.
4. Remove the 4 socket head screws (3) that secures the cutting unit assembly
(1) to the frame assembly (5).
Note:
Support the traction unit and lock the kick stand.
5. Slide and remove the cutting unit assembly (1) from the frame assembly (5).
6. If necessary, remove the dowel pins (4) from the frame assembly (5).
Greensmaster
®
e1021/e1026
Page 7–15
DPA Cutting Units: Service and Repairs
20246SL Rev A
Summary of Contents for 04831
