Disassembling the Roller
g261615
Figure 111
1.
Bearing lock nut (2 each)
3.
Ball bearing (2 each)
5.
Roller shaft
2.
Sealing washer (2 each)
4.
Wiehle roller
1. To hold the roller shaft (5) stationary while removing the bearing lock nut (1),
install a 3/8-24 UNF 2B screw with a jam nut into the threaded end of the
roller shaft (5) and tighten the jam nut against the roller shaft. Remove the
bearing lock nuts (1).
2. Carefully inspect the seating surface and threads of the bearing lock nuts (1)
and replace them if damaged.
3. Loosely secure the roller assembly (4) in a bench vise and lightly tap on the
roller shaft (5) to remove the sealing washers (2) and bearings (3). Discard
the sealing washers (2).
4. Clean and carefully remove any corrosion from the bearing cavities of the
roller.
DPA Cutting Units: Service and Repairs
Page 7–26
Greensmaster
®
e1021/e1026
20246SL Rev A
Summary of Contents for 04831
