Removing the Gear Box Assembly (continued)
3. Remove the drive shield.
g330867
Figure 116
1.
5/16–18 X 5/8 inch square head set screw 4.
Reel shaft
2.
Input shaft assembly
5.
Weld side of reel support plate
3.
Groomer gear box assembly
6.
Pry bar
4. Install a 5/16–18 X 5/8 inch square head set screw (Toro p/n 1-803022) in the
end of the drive shaft and tighten to
13 N·m (120 in-lb)
; refer to
.
5. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the groomer gear box. Discard the cotter pin.
6. Tip up the cutting unit to access the bottom of the reel to remove the drive
shaft assembly.
7. Insert a long-handled pry bar (3/8 x 12 inch with screwdriver handle
recommended) through the bottom of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
IMPORTANT
To avoid grinding the reel, do not contact the cutting edge of any
blade with the pry bar as this may damage the cutting edge and/or
cause a high blade.
8. Move the pry bar against the weld side of the reel support plate closest to
the groomer gear box.
IMPORTANT
You must use a 6-point socket with a heavy wall to remove the gear
box from the reel. Do not use an impact wrench. Groomer gear
boxes installed on the right side of the cutting unit use a standard
right hand thread; turn the drive shaft counterclockwise to remove
the gear box.
Greensmaster
®
e1021/e1026
Page 8–5
Universal Groomer (Optional): Service and Repairs
20246SL Rev A
Summary of Contents for 04831
