The Idler Assembly
g282209
Figure 121
1.
Cotter pin
6.
Shield
2.
Flange nut
7.
Retaining ring
3.
Flocked seal (2 each)
8.
Bearing
4.
Bushing
9.
Idler arm
5.
Stub shaft
10.
Clevis pin
The groomer idler assembly is located on the opposite side of the groomer gear
box.
Removing the Idler Assembly
Note:
Refer to
during this procedure.
1. Remove the reel drive from the cutting unit; refer to
.
2. Remove the groomer reel assembly; refer to
(page 8–14)
.
3. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
4. Remove the flange nut that secures the idler arm to the stub shaft. Remove
the idler assembly.
5. Inspect the shields, bearing, and bushing in the idler assembly. Replace any
components that are worn or damaged.
Universal Groomer (Optional): Service and Repairs
Page 8–12
Greensmaster
®
e1021/e1026
20246SL Rev A
Summary of Contents for 04831
