Installing the Idler Assembly
1. If the shields, bearing, or bushing was removed from the idler arm:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
C. Install the bearing shields with the flocked side of the shield toward the
bearing.
D. Insert the stub shaft through the shields and bearing. Use the through
hole in the shaft to prevent the shaft from rotating and tighten the flange
nut from
37 to 45 N∙m (27 to 33 ft-lb)
.
2. Install the clevis pin and a new cotter pin to secure the height adjustment rod
to the front of the idler arm.
3. Install the reel drive; refer to
Installing the Reel Drive Assembly (page 4–10)
.
Greensmaster
®
e1021/e1026
Page 8–13
Universal Groomer (Optional): Service and Repairs
20246SL Rev A
Summary of Contents for 04831
