The Height Adjuster Assembly
g282214
Figure 124
1.
Cotter pin
7.
Compression spring
13.
Quick up cover
2.
Clevis pin
8.
Bumper
14.
Detent spring
3.
Height adjustment rod
9.
Lock nut
15.
Button-head screw
4.
Flange nut
10.
Pinch bolt
16.
Height adjuster knob
5.
Washer (2 each)
11.
Height-of-cut bracket
17.
Height adjustment bolt
6.
Compression spring
12.
Quick up lever
18.
Plow bolt
Note:
Early universal groomers used 2 compression springs on non-adjustable
height adjustment rods. Retrofitting the assemblies on each side of the cutting
unit with new compression springs, height adjustment rods, and adding flange
nuts to enable spring adjustment is recommended; refer to
Disassembling the Height Adjuster
Note:
Refer to
during this procedure.
1. Remove the cutting unit from the machine.
2. Remove the cotter pins and clevis pins that secure the height adjustment
rods to the groomer gear box and idler arm. Discard the cotter pins.
3. Loosen the pinch bolts that secure the front roller to the height-of-cut
brackets.
Greensmaster
®
e1021/e1026
Page 8–17
Universal Groomer (Optional): Service and Repairs
20246SL Rev A
Summary of Contents for 04831
