" !" #"!
!" " !
Safe operation begins before taking the vehicle out for
a day's work. You should check these items each time:
Check all fluid levels and add the appropriate
amount of Toro specified fluids, if any are found to be
low.
Check brake pedal operation.
Check to see that the horn is working.
Turn steering wheel to the left and right to check
steering response.
Check for oil leaks, loose parts and any other
noticeable malfunctions. Make sure engine is off and
all moving parts have stopped before checking for oil
leaks, loose parts and other malfunctions.
If any of the above items are not correct, notify your
mechanic or check with your supervisor before taking
the vehicle out for the day. Your supervisor may want
you to check other items on a daily basis, so ask what
your responsibilities are.
!" "
"" ",) *8)0 6;67)1 1867 &) &0)( -* %2; 3*
7,) *3003:-2+ 6-78%7-326 ,%9) 3''855)(
2-7-%0 67%57 84 3* % 2): 1%',-2)
2+-2) ,%6 ')%6)( 5822-2+ (8) 73 0%'/ 3*
*8)0
%-27)2%2') ,%6 &))2 4)5*351)( 8432 *8)0
6;67)1 '31432)276 -) *-07)5 5)40%')(
6)4%5%735 6)59-')( )7'
)*)5 73 0))(-2+ ",) 8)0 !;67)1
Sit on operator's seat and engage parking brake.
Move shift lever to NEUTRAL position and depress
clutch pedal.
Keep foot off accelerator pedal.
When temperature is below 15
_
C (60
_
F), push
glow plug switch upward to ON position (Fig. 18) and
hold for suggested interval.
37)
Do not exceed 30 seconds of continuous use or
glow plug may burn out prematurely.
37)
Refer to chart indicating approximate preheat
time suggested in various temperature ranges.
")14)5%785)
5),)%7 7-1) 6)'
Above 5
_
C (41
_
F)
10
+5
_
C (41
_
F) to
20
-5
_
C (23
_
F)
Below -5
_
C (23
_
F)
30
Insert key into ignition switch and rotate it
clockwise to start the engine. Release key when
engine starts.
37)
Do not run starter motor more than 20 seconds
at a time or premature starter failure may result. If
engine fails to start after 20 seconds, turn key to OFF
position, recheck controls and procedures, wait 10
additional seconds and repeat starter operation.
Ensure that the lights are on.
# !$!"
Loosen air bleed screw on top of fuel filter/water
separator (Fig. 20).
-+85)
8)0 *-07)5:%7)5 6)4%5%735
-5 &0))()5 6'5):
Turn key in ignition switch to the ON position.
Electric fuel pump will begin operation, thereby forcing
air out around air bleed screw. Leave key in ON position
until solid stream of fuel flows out around screw.
Tighten screw and turn key to OFF.
Open the air bleeder screw on the fuel injection
pump (Fig. 21) with a 10 mm wrench.
-+85)
8)0 -2.)'7-32 4814 &0))()5
Turn key in ignition switch to the ON position.
Electric fuel pump will begin operation, thereby forcing
air out around air bleed screw on fuel injection pump.
Leave key in ON position until solid stream of fuel flows
out around the screw. Tighten screw and turn key to
OFF.
