" !
"!
#
()24( 5(48,&,1* 24 0$.,1* $'-7560(165 62 6+(
0$&+,1( 5623 (1*,1( 5(6 3$4.,1* %4$.( $1'
4(028( .(; )420 ,*1,6,21 59,6&+ 1; /2$' 0$<
6(4,$/ 0756 %( 4(028(' )420 %(' 24 26+(4 $6<
6$&+0(16 %()24( 924.,1* 71'(4 4$,5(' %(' /<
9$;5 3/$&( 6+( 5$)(6; 5733246 21 (:6(1'(' /,)6
&;/,1'(4 62 +2/' %2: 73
"
,*
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base
Grease. If machine is operated under normal
conditions, lubricate all bearings and bushings after
every 100 hours of operation. More frequent lubrication
is required if used for heavy duty vehicle operations.
The grease fitting locations and quantities are: Tie rod
ends (4) (Fig. 24), Front ball joints (4) (Fig. 24), Rear
drive shafts (18) (Fig. 25) Front pivot bushings (2)
(Fig. 26); Pedal Pivots (4) (Fig. 27); Steering shaft (1)
(Fig. 28) and Accelerator Arm (1) (Fig. 29).
!!
When greasing drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
Wipe grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
Pump grease into the bearing or bushing.
Wipe off excess grease.
,*74(
,*74(
