Figure 61
1.
Tie rods
2.
Jam nuts
B. Rotate the tie rod to move the front of the tire
inward or outward to achieve the center to center
distances from front to back.
C. Tighten the tie rod jam nut when the adjustment
is correct.
D. Check to ensure that the tires turn an equal
amount to the right and to the left. If the tires do
not turn equally, refer to the Workman Service
Manual for the adjustment procedure
Cooling System
Maintenance
Removing Debris from the
Cooling System
Service Interval:
Before each use or daily (Clean more
frequently in dirty conditions.)
1. Turn the engine off. Clean the engine area
thoroughly of all debris.
2. Unlatch and remove the radiator screen from the
front of the radiator (Figure 62).
Figure 62
1.
Radiator screen
2.
Latch
3. If so equipped, rotate the latches and pivot the oil
cooler away from the radiator (Figure 63).
Figure 63
1.
Radiator housing
3.
Latches
2.
Oil cooler
4. Clean the radiator, oil cooler, and screen thoroughly
with compressed air.
Note:
Blow debris away from the radiator.
5. Install the cooler and screen to the radiator.
49
Summary of Contents for 07367TC
