2004—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Printed in the USA
All Rights Reserved
Original Instructions (GB)
Register your product at www.Toro.com
Replacement Shroud Kit
2002 and After CCR
t
2450 and 3650
International Snowthrowers
Part No. 108-3752
Form No. 3352-117 Rev B
Installation Instructions
Removing the Existing Lower
Shroud from the Snowthrower
1.
Remove the 2 bolts that secure the existing lower
shroud to the snowthrower.
Note:
Save the bolts you removed to secure the new
lower shroud onto the snowthrower.
m–7757
A
2.
Pull the top of the shroud to the rear until the
choke lever (A above) clears the slot.
3.
Remove the shroud.
4.
Remove the rubber choke shield from the choke
lever and discard the shield.
Installing the New Lower Shroud
onto the Snowthrower
1.
As you install the new lower shroud onto the
snowthrower, guide the choke lever through the slot.
2.
Secure the new lower shroud with the 2 bolts you
previously removed.
Note:
Ensure that the lip of the new lower shroud (A)
tucks into the cross tube (B) of the snowthrower.
m–7756
A
B
