Figure 23
1.
90° hydraulic fitting
3.
Port C2 (hydraulic control
manifold)
2.
Port C1 (hydraulic control
manifold)
4.
Install 2 new straight fittings (9/16 x 9/16 x 3/8 inch)
into ports C3 and C4 (
Figure 24
1.
Female quick disconnect
coupling
4.
Male quick disconnect
coupling
2.
Straight fittings (9/16 x
9/16 x 3/8 inch—new)
5.
Port C3 (hydraulic control
manifold)
3.
Port C4 (hydraulic control
manifold)
5.
Install the male quick disconnect coupling that you
removed in step
of
onto the straight hydraulic fittings
(9/16 x 9/16 x 3/8 inch) in port C3 (
6.
Install the female quick disconnect coupling that you
removed in step
of
onto the straight hydraulic fittings
(9/16 x 9/16 x 3/8 inch) in port C4 (
8
Installing the Manifold Bracket
and Hydraulic Control Manifold
Parts needed for this procedure:
1
Flat manifold bracket
1
Flanged manifold bracket (HDX-Auto Workman
models)
2
Bolt (5/16 x 3/4 inch)
2
Lock washer (5/16 inch)
Install the Manifold Bracket
(non-HDX-Auto Workman models)
1.
Align the holes in the flat manifold bracket to the holes
in the flange of the transaxle support (
).
Figure 25
1.
Flanged-head bolt
3.
Manifold bracket
2.
Transaxle support
4.
Flanged locknut
2.
Secure the bracket to the support with the 2
flanged-head bolts and 2 flanged locknuts (
)
that you removed in step
of
Disconnect Bracket (page 10)
.
12
