Form No. 3362-196 Rev A
50in Recycler Kit
for TITAN Zero-Turn-Radius Riding Mower
Model No. 117-5312
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the mower.
Left baffle
1
Right baffle
1
Knob
4
2
Curved washer
4
Install the upper baffle.
Kicker plate
3
3
Phillips head screw (#8 x 5/8 inch)
6
Install the kicker plates.
4
Recycling decal
1
Instal the decal.
5
Recycling mower blade
3
Install the blades and mower
1
Preparing the Mower
No Parts Required
Procedure
1. Stop the engine and remove the ignition key.
2. Remove the mower as described in your
Operator’s
Manual
.
3. Turn the mower upside down.
4. Remove the mower blades as described in your
Operator’s Manual
.
2
Installing the Baffles
Parts needed for this procedure:
1
Left baffle
1
Right baffle
4
Knob
4
Curved washer
Procedure
1. Locate the four holes in the mower where the baffle
mounting studs will mount (Figure 1) and remove
any fasteners from them.
2. Install the left baffle into the deck securing the studs
on the baffle from the top of the mower using 2
knobs and curved washers (cupped side facing the
mower) as shown in Figure 1 and Figure 2.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
