3
Installing the Kicker Plates
Parts needed for this procedure:
3
Kicker plate
6
Phillips head screw (#8 x 5/8 inch)
Procedure
1. Align the three kicker plates with holes toward the
top of the deck (Figure 3). The long slope of the
kickers must be face inward.
Figure 3
1.
Mower deck
2.
Kicker plate, installed
2. If there are rivets blocking the mounting holes in the
mower, drill out the center of each rivet with a 3/16
inch (5 mm) drill bit and discard the rivet.
3. Secure the plates to the deck using six Phillips head
screws (#8 x 5/8 inch). The screws come up through
the top of the mower and into the plate (Figure 3).
4
Installing the Decal
Parts needed for this procedure:
1
Recycling decal
Procedure
Install the decal on left side of mower (Figure 4).
Figure 4
1.
Recycler decal
2.
Left side of mower
5
Installing the Blades and
Mower
Parts needed for this procedure:
3
Recycling mower blade
Procedure
1. Install the new recycling mower blades as described
in your
Operator’s Manual
.
2. Install the mower as described in your
Operator’s
Manual
.
3
