Form No. 3389-137 Rev A
Multi Pro
®
WM Turf Sprayer Finishing Kit
Manual Workman
®
Utility Vehicle
Model No. 131-3302
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Use of this product may cause exposure to chemicals known to the State of California
to cause cancer, birth defects, or other reproductive harm.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
Drive-shaft-shield bracket
1
Install the drive-shaft shield on the
sprayer pump.
PTO drive shaft
1
Woodruff key
1
Set screw
2
Drive-shaft shield
1
Clip
2
2
Flange-head bolt (1/4 x 3/4 inch)
2
Install the PTO shaft and the drive-shaft
shield to the sprayer pump.
Hydraulic hose (5/8 x 55.6 inches)
1
Hydraulic hose (5/8 x 85.2 inches)
1
Male quick coupler
1
Female quick coupler
1
Tube clamp
2
Clamp bolt (5/16 x 1-1/2 inches)
1
3
Cable tie
3
Install the hydraulic hoses for the boom
lift cylinders.
4
No parts required
–
Couple the PTO shaft to the transaxle.
Note:
Remove the cargo box or flatbed from the vehicle before installing this kit; refer to the
Operator’s Manual
for the vehicle.
Note:
For Non-TC models, install the Rear PTO Kit before installing this kit; contact your Authorized Toro Distributor
about purchasing this kit.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3389-137* A
