Form No. 3392-387 Rev B
34in Striping Kit
Zero-Turn-Radius Riding Mower
Model No. 131-4167
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
Washer-head screw (5/16 x 3/4 inch,
self-threading)
4
Mounting bracket
2
Striping bracket
1
Install the striping kit bracket assembly.
Hex-head screw (5/16 x 3/4 inch)
4
Washer
4
Clip nut
4
Wiper
1
Installing the striping kit wiper.
Removing the Mower Deck
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Engage the parking brake, stop the engine, remove the
key, and wait for all moving parts to stop before leaving
the operating position.
3.
Remove the mower deck from the machine. Refer
to the Removing the Mower section in the
Operator's
Manual
or the appropriate section of the
Service Manual
.
WARNING
The belt tension spring is under tension when
installed and can cause personal injury.
Be careful when removing the mower belt and
deck.
4.
Slide the mower deck out from underneath the
machine.
5.
Clean the back of the mower deck.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3392-387* B
