5
IDENTIFICATION DATA
For technical assistance or to request replacement parts, always give the model, the version and serial number written on the serial number
plate.
TECHNICAL DESCRIPTION
INTENDED USE
SAFETY
SERIAL NUMBER PLATE
This appliance has been built for the professional cleaning of indoor hard vinyl floors, to be carried out by following the instructions.
The
appliance must only be used for this purpose.
This appliance was designed and built to be used by a qualified
operator to clean smooth, compact flooring in the commercial,
residential and industrial sectors, in proven safety conditions.
Operator cooperation is paramount for accident prevention. No
accident prevention programme can be effective without the full
co-operation of the operator who is directly responsible for machine
operation. The majority of occupational accidents that happen both
in the workplace or whilst moving are caused by failure to respect
The serial number plate is located on the lower part of the machine
chassis, and indicates the general characteristics of the appliance,
in particular the appliance's serial number. The serial number is a
very important piece of information and should always be provided
together with any request for assistance or when purchasing spare
parts.
The appliance is only suitable for use in indoor - or at least covered
- areas.
ATTENTION:
The appliance is not suitable for use in the rain,
or under jets of water.
the most basic safety rules. An attentive, careful operator is the most
effective guarantee against accidents and is fundamental in order to
implement any prevention programme.
5
EN
TECHNICAL DATA
U/M
TORO
Working width
mm - inch
430-16.9
Number of orbit
orb./min.
1400
Brush head motor rated power
W
1100
Brush head motor nominal voltage
V
115
Brush head motor frequency
Hz
50
Maximum gradient with full load
%
2
Solution tank capacity (optional)
l - gal
15 - 3.96
Rear wheels (diameter / width)
mm - inch
200/50
7.8/1.96
Appliance length
mm - inch
565 - 22.25
height of the appliance to the brush head cover
mm - inch
325 - 12.8
Height of the appliance to the shaft
mm - inch
1160 - 45.7
Appliance width
mm - inch
450 - 17.7
Appliance service weight (without solution tank)
kg - Lb
41 - 90.4
Hand vibration level
m/s
2
1.9
Uncertainty of measurement of vibrations
m/s
2
0.7