Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1.
Move the transport lock to the L
OCK
position.
2.
Push on the deck-lift pedal with your foot and
raise the mower deck to the T
RANSPORT
position
(also the 127 mm or 5 inch cutting-height
position) as shown in
3.
Remove the pin from the height-of-cut bracket
(
).
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (
5.
Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
g327983
Figure 29
1.
Deck-lift pedal
3.
Height-of-cut pin
2.
Height-of-cut holes
4.
Transport lock knob
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1.
Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
and
g321510
Figure 30
1.
Flange nut
4.
Anti-scalp roller
2.
Bolt
5.
Spacer
3.
Bushing
g036848
Figure 31
1.
Flange nut
4.
Anti-scalp roller
2.
Bolt
5.
Spacer
3.
Bushing
28
Summary of Contents for 2000 Series
